卖[物聯汪汪] 含稅附發票~原廠國際版 STLINK ST-LINK V2 ICE/模擬器 支援STM8 STM32最好的价格

本賣場商品一律含稅開發票，需要統編者請下單後備註公司名及統編即可! 本店近新店捷運總站，歡迎大家來店自取，需要自取的可在蝦皮留言通知。 原廠網址: https://www.st.com/en/development-tools/st-link-v2.html ****請注意出售的是左圖ST-LINK V2, 而不是右圖ISOL版本! The ST-LINK/V2 is an in-circuit debugger and programmer for the STM8 and STM32 microcontroller families. The single wire interface module (SWIM) and JTAG/serial wire debugging (SWD) interfaces are used to communicate with any STM8 or STM32 microcontroller located on an application board. In addition to provide the same functionalities as the ST-LINK/V2, the ST-LINK/V2-ISOL features digital isolation between the PC and the target application board. It also withstands voltages of up to 1000 Vrms. STM8 applications use the USB full-speed interface to communicate with the ST Visual Develop (STVD) or ST Visual Program (STVP) software. STM32 applications use the USB full-speed interface to communicate with Atollic®, IAR™, Keil®or TASKING integrated development environments. Key Features 5 V power supplied by a USB connector USB 2.0 full-speed-compatible interface USB standard A to Mini- B cable SWIM specific features 1.65 V to 5.5 V application voltage supported on SWIM interface SWIM low-speed and high-speed modes supported SWIM programming speed rate: 9.7 Kbytes/s in low speed and 12.8 Kbytes/s in high speed SWIM cable for connection to the application via an ERNI standard vertical connector (ref: 284697 or 214017) or horizontal connector (ref: 214012) SWIM cable for connection to the application via a pin header or a 2.54 mm pitch connector JTAG/serial wire debugging (SWD) specific features: 1.65 V to 3.6 V application voltage supported on the JTAG/SWD interface and 5 V tolerant inputs JTAG cable for connection to a standard JTAG 20-pin pitch 2.54 mm connector JTAG supported SWD and serial wire viewer (SWV) communication supported Direct firmware update feature supported (DFU) Status LED which blinks during communication with the PC Operating temperature 0 to 50 °C 1000 Vrms high isolation voltage (ST-LINK/V2-ISOL only)